Anritsu MS2711D Spectrum Master™

• Handheld, battery-operated design
• Built in pre-amplifier (standard)
• Lightweight at only 4.9 lbs
• Noise Level < -135 dBm typical (preamp on)
• Quick Zoom-in, Zoom-out display in 1-2-5 sequence
• RBWs: 100 Hz to 1 MHz in 1-3 sequence
• VBWs: 3 Hz to 1 MHz in 1-3 sequence
• Automatic, manual, and dynamic attenuator control
• Amplitude Accuracy +/- 0.5 dB typical
• Dedicated smart measurements
• Trace Averaging
• Reference Level Offset
• Trace Overlay
• Multilingual User Interface (English, Chinese, French, German, Japanese, Spanish)
• Store up to 15 measurement test set-ups
• Save up to 200 measurement traces
• Alphanumeric labeling of saved measurements
• Automatic time and date stamp of saved data
• Rechargeable/field-replaceable battery
• 6 Markers, limit lines and segmented limit lines
• 50-ohm Interface standard (75-ohm interface capability – instrument internally corrects for adapter loss)
• RS232 Interface
• Built in AM, FM and SSB demodulation
• Transmission Measurement, 25 MHz to 2.5 GHz (option 21)
• Power Meter (option 29)

Anritsu MS2711D Spectrum Master™ Options

Add these options to expand functionality in your spectrum analyzer:

• Option 5 – Power Monitor uses external power detectors for broadband power measurements up to 50 GHz
• Option 6 – Frequency Converter Module Controller available (option 6) for use with Anritsu FCN4760 4.7 to 6.0 GHz Down Converter
• Option 10 – Provides 12 to 24 volts at 6 watts maximum steady state
• Option 19 – High Accuracy Power Meter (sensor PSN50 not included)
• Option 21 – Transmission Measurement provides tracking output from 25 MHz to 2.5 GHz
• Option 25 – Interference Analysis provides spectrogram display, RSSI (Received Signal Strength Indication) and signal strength with audio output for radio direction finding.
• Option 27 – Channel Scanner displays amplitude of multiple channels of supported air interface standards.
• Option 28 – CW Signal Generator used with an external attenuation kit, Anritsu part number 61534, provides a CW signal for base station sensitivity measurements.
• Option 31 – Built-in GPS adds a GPS receiver and connector for an external antenna. Available accessory cables allow the GPS antenna to be placed to have a clear view of the sky.